There are a few things you’ll need to install an AR-15 lower parts kit. You’ll need a vise, screwdriver, hammer, and punches. The first step is to remove the pistol grip and the stock. To do this, use the screwdriver to remove the screws on the pistol grip and the stock. Once they’re removed, take the grip and stock off of the firearm.
The next step is to place the firearm in a vise. If you don’t have a vise, you can use some clamps. Once it’s in place, use a punch to drive out the pins that hold the lower receiver together. There are four pins in total – two on each side. Once they’re removed, the upper and lower receivers will come apart.
Now, it’s time to install the new parts. Take the trigger assembly and place it in the lower receiver. Then, put the disconnector and spring in place. Next, install the hammer and spring. Finally, put the selector switch in place.
Once all of the new parts are in place, it’s time to reassemble the lower receiver. First, put the upper and lower receivers back together. Then, replace the pins that hold them together. Finally, screw the pistol grip and stock back on.
Your AR-15 lower parts kit is now installed!
It depends on the lower parts kit. Some kits come with a bolt carrier group and charging handle, while others don’t.
First, you need to remove the pistol grip and selector switch from the old lower receiver. Once those are removed, install them on the new lower parts kit. Next, install the takedown pins, buffer tube, and stock. Finally, install the bolt carrier group and charging handle. See your specific kit’s instructions for more detailed instructions.
There are a few different ways you can install a AR 15 lower parts kit. You can either do it yourself or have a gunsmith do it for you. If you’re doing it yourself, you’ll need to have some basic tools and knowledge of how to use them. The most important thing is to make sure that everything is properly aligned and that all the screws are tight.
If you’re having a gunsmith do it for you, they should be able to do it relatively quickly and easily. All they’ll need is the lower parts kit itself, and they’ll take care of the rest. Just make sure that you choose a reputable gunsmith who has experience with AR 15s.
There are a few things you need to know before you install an AR-15 lower parts kit. First, be sure to read the owner’s manual that came with your rifle. There may be specific instructions on how to install the lower parts kit that is unique to your weapon. Second, always use caution and safety precautions when working with firearms.
To install an AR-15 lower parts kit, you will need a vise, punches, needle nose pliers, Allen wrenches, and a hammer. The first step is to remove the pistol grip from the rifle. To do this, use a punch to drive out the retaining pin from the grip. Next, remove the screw that holds the grip in place and pull it off.
With the pistol grip removed, you will see the hole for the buffer tube. This is where you will install the new parts kit. Take the new receiver extension and place it in the buffer tube hole. Be sure that it is lined up correctly and start to thread it in. Once it is hand-tight, use an Allen wrench to finish tightening it.
Now, take the new castle nut and place it on the receiver extension. Again, be sure that it is lined up correctly and start to thread it on. Once it is hand-tight, use an Allen wrench to finish tightening it. You may need to use a mallet or hammer to get the castle nut started, but be careful not to damage the threads.
Finally, replace the pistol grip by reversing the process that you used to remove it. Be sure that the retaining pin is in place and start to screw the grip back on. Once it is hand-tight, use an Allen wrench to finish tightening it.
You have now successfully installed an AR-15 lower parts kit. Be sure to test the weapon before using it to make sure that everything is working correctly. If you have any questions, be sure to consult the owner’s manual or a qualified gunsmith.