- Drill a hole in the center of the can
- Insert the barrel of the gun into the can and trace around it with a permanent marker
- Cut out the traced circle with a sharp knife or an electric saw
- File down any sharp edges or burrs on the newly cut edge until it’s smooth
- Take off the end of the shotgun barrel, and insert the suppressor onto the barrel until it’s tightly fitted
- Make sure there are no gaps between the suppressor and barrel, and then use epoxy to glue them together if necessary
- Let the epoxy dry completely before using your new gun suppressor!
Assuming you are referring to a firearm suppressor (also called a silencer), there are a few things you need to do to properly attach it. First, you’ll need to drill a hole in the center of the can. Next, insert the barrel of the gun into the can and trace around it with a permanent marker. After that, carefully cut out the traced circle with a sharp knife or an electric saw. Finally, file down any sharp edges or burrs on the newly cut edge until it is smooth.
If you are attaching the suppressor to a shotgun, you’ll also need to take off the end of the shotgun barrel before inserting the suppressor.
Eric Answered question September 12, 2022