A step-by-step guide to drying lube from a gun magazine:
- Remove the magazine and all rounds from the firearm.
- Locate a safe place to clean and work on the firearm, such as an outdoor shooting bench or table.
- Liberally apply Gunslick® Pro Dry Lube to a clean cloth and wipe down all surfaces of the magazine.
- Allow the lubricant to air dry completely before reassembling the magazine into the firearm.”
- Once the magazine is dry, reinsert it into the firearm and load rounds as usual.
If you have any further questions, please feel free to contact us.
There are a few ways to dry lube gun magazines. One is to use a blow dryer on low heat. Another is to place the magazine in direct sunlight. A third is to use a food dehydrator on the lowest setting. All of these methods will help evaporate any remaining lubricant and prevent it from collecting dirt and dust.
It’s easy! All you have to do is remove the magazine, spread a thin layer of gun oil over the entire surface of the magazine (inside and out), let it dry for about 15 minutes, then reinsert it into your gun.
Make sure you only use a high-quality gun oil, like Break-Free CLP, since some cheaper oils can cause more harm than good.
And don’t forget to apply a fresh coat of oil every few months (or more often if you shoot a lot). That’s it – easy as pie!
If you’re looking for a more in-depth guide on how to clean and lubricate your gun magazines, check out this article.
There is no one-size-fits-all answer to this question, as the best way to dry lube a gun magazine will vary depending on the type of lube used. However, a few tips on how to dry lube a gun magazine include using compressed air, using a heat gun, or using Naptha or denatured alcohol.
A simple way to dry lube a gun magazine is to put it in the oven on a low setting. The heat will help evaporate any moisture that may be inside the magazine and will help keep the gun functioning properly. You should always make sure that the magazine is completely dry before using it again.