Does anyone have any advice on how to remove these grips without damaging the rubber on Smith & Wesson M&P gun?
Here is a guide on how to remove the rubber grip from an M&P gun.
- Use a heat gun or hair dryer to heat the grip around the gun.
- Carefully peel back the grip from the gun.
- If any adhesive remains on the gun, use Goo Gone or another type of adhesive remover to remove it.
- Wipe down the gun with a clean cloth to remove any residue from the adhesive or heat gun/hair dryer.
Removing the rubber grip from an M&P gun can be a tricky process, but with a few simple steps, it can be done. Begin by removing the screws that hold the grip in place. Next, use a flat head screwdriver to pry the grip off of the gun. If the grip is stubborn and doesn’t want to come off, try using a little bit of force until it pops off. Finally, reattach the screws and your gun is ready to go!
There are a few ways to remove the rubber grip from an M&P gun. One is to use a heat gun or hair dryer to soften the adhesive and then peel it off. Another is to use a solvent such as acetone or fingernail polish remover to dissolve the adhesive. A third option is to use a sharp object such as a razor blade or X-ACTO knife to cut between the grip and the frame of the gun. Be very careful not to cut yourself while doing this!
Once the rubber grip is removed, you can clean off any residual adhesive with acetone or fingernail polish remover. If you plan on replacing the grip, make sure to clean the area thoroughly before applying the new one.
There are a few ways to remove the rubber grip from the M&P gun. One way is to use a heat gun or hair dryer to heat the rubber grip until it becomes soft and then peel it off. Another way is to use a solvent such as paint thinner, acetone, or Goo Gone to dissolve the adhesive that holds the grip in place. Be sure to clean any residue left behind by the solvent with a rag and some mineral spirits.